Elmo Rietschle L-NEV2
Elmo Rietschle ·Made in Germany · In Active Production

Elmo Rietschle L-NEV2

Elmo Rietschle L-NEV2 — Liquid Ring Vacuum Pumps with Max inlet pressure 2.7 kPa, Motor power 0.81 kW, Pumping speed 27 m³/h.

The L-NEV2 is an oil-free liquid ring vacuum pump in the NEV2 series, operating at 50 Hz with a 0.81 kW motor and 220 V supply. It delivers 27 m³/h pumping speed at a maximum inlet pressure of 27 mbar, distinguishing it as a compact, low-capacity unit within the series. Its primary purpose is to provide clean, oil-free vacuum for processes where contamination from lubricants is unacceptable.

Max inlet pressure
2.7 kPa
Motor power
0.81 kW
Pumping speed
27 m³/h

Full specifications

Core Performance & Functional Specifications
Max inlet pressure 27 mbar (50 Hz)
Motor power 0.81 kW (50 Hz)
Operating principle Liquid Ring
Pumping speed 27 m³/h (50 Hz)
Dimensions, Weight & Mechanical Design
Height 90 mm (50/60 Hz)
Length 456 mm (50/60 Hz)
Weight 24 kg (50 Hz)
Width 186 mm (50/60 Hz)
Electrical, Power & Drive Specifications
Power supply 220 V (50 Hz)
Operating Conditions, Environment & Protection
Noise level 62 dB (50 Hz)

Description

Construction and Positioning

Performance and Behavior

Installation and Operation

Integration & Operating Notes

Process Limits
Ultimate pressure is 27 mbar absolute

The pump achieves an ultimate pressure of 27 mbar absolute. Operating at lower absolute pressures (deeper vacuum) may cause cavitation and loss of liquid ring integrity, leading to vibration and damage. Ensure the process pressure is controlled and monitored, especially during startup or upset conditions.

Factory Specification Sheet
Electrical
Supply voltage must match 220 V at 50 Hz

The motor is designed for 220 V, 50 Hz. Operating at higher voltage or frequency can overheat the motor and void warranty. Verify supply stability and use appropriate protection.

Factory Specification Sheet
Maintenance
Regularly check service liquid quality and flow

The liquid ring performance depends on clean service liquid. Inspect filters and ensure flow rate is within specification. Contaminated liquid can cause erosion and reduced vacuum.

NEV2 Series Liquid Ring Pump Manual

Selection & Integration Q&A

When should I choose the L-NEV2 over other NEV2 series models like NEV2 060 or NEV2 070?

Choose L-NEV2 for low-capacity, oil-free vacuum needs up to 27 m³/h with an ultimate pressure of 27 mbar. Larger models like NEV2 070 offer higher flow; select based on required pumping speed and ultimate pressure.

What are the requirements for the service liquid supply and piping when integrating the L-NEV2?

The pump requires a continuous supply of clean, compatible liquid (typically water) at a flow rate sufficient to maintain the ring. Piping should be sized to avoid pressure drop, and discharge must handle two-phase flow.

What are the mounting and environmental limits for the L-NEV2 according to the manual?

Mount on a level surface in a well-ventilated area, ambient temperature typically 0–40°C. Avoid corrosive atmospheres unless the stainless steel variant is used. Ensure adequate clearance for maintenance.

What maintenance items and accessories are not included with the base pump?

Base delivery includes the pump only. Service liquid filtration, piping, valves, and control instruments are not included. Regular maintenance includes checking liquid quality and inspecting seals; spare parts kits are available separately.

Dimensional Drawings & Technical Documentation

Technical documentation

PDF
NEV2 Series Liquid Ring
Datasheet ·2,9 МБ ·12 pp.
View PDF