Nabertherm DF 36/320/5/10 WK
Nabertherm DF 36/320/5/10 WK — Furnaces Microelectronic Industry.
The DF 36/320/5/10 WK is a continuous belt furnace with a 360 mm belt width and 3200 mm heated length, divided into 7 heating zones and rated for a maximum temperature of 1050 °C. Its 47 kW installed heating power is distributed across the zone train to support a controlled burn-out and firing/sintering profile. It is intended for continuous thermal processing in microelectronic and related production lines.
Full specifications
| Number of heating zones mfr | 7 |
| Heating power1 mfr | 47 |
| Belt width mfr | 360 |
| Heated length mfr | 3200 |
| Max temperature | 1050 °C |
Description
Construction and series positioning
- Continuous belt furnace architecture: a 360 mm wide belt carries work through a 3200 mm heated length.
- The heated section is split into 7 independently arranged heating zones, with 47 kW total heating power.
- Maximum working temperature is 1050 °C.
- No sibling models are defined in the supplied facts, so positioning within the series is limited to the stated belt width, heated length and zone count.
Thermal behavior
- No digitized curve points were supplied, so heat-up, uniformity and cooling behavior cannot be quantified here.
- The 7-zone layout and 47 kW power indicate a profile-capable furnace, but the actual achievable profile depends on load, belt speed and atmosphere, none of which are given.
- The 1050 °C ceiling is the only verified thermal limit; operation above it is not supported by the supplied data.
Control and documentation
- The attached controller digest covers Nabertherm series 500 controllers and the MyNabertherm app, including process data storage and AMS2750F instrumentation types, but it does not state which controller is fitted to this model.
- The other attached digests (fiber optics, foundry, dental) do not describe this furnace; they should not be used to infer its configuration.
- Installation, connection and operating specifics for this exact model are not available in the supplied documents.
Integration & Operating Notes
The only verified thermal limit is a maximum temperature of 1050 °C. Because the furnace has 7 heating zones, the setpoint of each zone and the resulting work temperature must be checked so that no zone or product excursion exceeds this ceiling; doing so risks damage to the furnace and invalid results.
The installed heating power is 47 kW, which is a substantial load for a production line. Electrical supply voltage, phase configuration and protection are not stated in the supplied facts, so the supply design must be confirmed against the actual nameplate and wiring diagram before installation.
No maintenance intervals, belt replacement guidance or error-code procedures for this model are included in the supplied documents. A maintenance plan for the belt drive and the 7 heating zones must be obtained from the model-specific instruction manual before commissioning.
Selection & Integration Q&A
Choose it when the process needs a 360 mm belt and a 3200 mm heated length at up to 1050 °C with 7-zone profiling. No sibling models are defined in the supplied facts, so alternatives cannot be compared on belt width, length or zone count here.
The 47 kW heating power load must be matched to the site supply, but voltage and phase are not stated in the supplied facts. The controller is likewise not fixed: the series 500/MyNabertherm digest describes options, not the fitted package, so both must be confirmed on the nameplate and order documents.
The supplied documents give no installation clearances, floor loading or duty-cycle data for this model. The only verified limit is the 1050 °C maximum temperature; all mounting and cycling requirements must come from the model-specific manual.
No maintenance intervals, spare belts, thermocouples or recorder accessories are listed in the supplied facts. The controller digest mentions recorder and instrumentation options but does not tie them to this model, so consumables and service parts must be specified separately.