Waters Aura PTx System
Waters ·Made in USA · In Active Production

Waters Aura PTx System

Waters Aura PTx System — Particle size analyzers.

The Aura PTx System is a benchtop particle size analyzer combining brightfield microscopy (4x objective, 24.6 mm² imaging area, 1.0 pixel/µm resolution) with flow imaging for particles from >1 µm to <5 mm ECD. It delivers BMI results in 1 minute per sample and FMM results in 30 seconds per sample across two FL channels, requiring only 5 µL minimum volume. It is used for rapid, image-based particle characterization in laboratory quality control and formulation workflows.

Direct drop-in replacements

Shimadzu
Aggregates Sizer
0%
match
⚖️ Compare
Shimadzu
Ispect DIA 10
0%
match
⚖️ Compare
Shimadzu
SALD-2300
0%
match
⚖️ Compare
Shimadzu
SALD-7500nano
0%
match
⚖️ Compare

Full specifications

Core Performance & Functional Specifications
Imaging area mfr 24.6 mm2
Optics mfr 4x objective
Minimum volume mfr 5 μL (assay dependent)
Resolution mfr 1.0 pixel/μm
Detectable size range mfr >1 μm (ECD) to <5 mm (ECD)
BMI read time mfr 1 minute/sample
FMM read time mfr 2 FL channels, 30 seconds/sample
Software mfr Particle Vue 4.x all-in-one Software suite

Description

Construction and positioning

Integration & Operating Notes

Process Limits
Minimum sample volume of 5 µL is assay dependent

Operating below the assay-dependent minimum volume may prevent proper flow imaging and yield invalid results. The 5 µL lower limit must be validated for each assay before routine use, as actual required volume depends on sample concentration and flow cell characteristics.

Factory Specification Sheet
Control & I/O
Particle Vue 4.x software suite controls all acquisition modes

The system requires the Particle Vue 4.x all-in-one software for operation. Ensure the controlling PC meets the software's system requirements and that the instrument is connected via the specified interface before initiating BMI or FMM runs.

Factory Specification Sheet
Maintenance
Regular cleaning of the flow path is required to prevent blockage

After each use, flush the flow system with appropriate cleaning solution to avoid particle accumulation and clogging, which can degrade imaging quality and cause erroneous size measurements. Follow the manufacturer's cleaning protocol in the instrument manual.

Instruction Manual, Maintenance Section

Selection & Integration Q&A

When should I choose the Aura PTx System instead of a different particle size analyzer?

Choose the PTx when you need image-based morphological data (shape, size) from 1 µm to 5 mm with fast read times (1 min BMI, 30 s FMM) and low sample volume (5 µL). For pure ensemble sizing without imaging, a different technique may be more suitable.

Dimensional Drawings & Technical Documentation

Technical documentation