Eppendorf Centrifuge 5418 R
Eppendorf ·Made in Germany · In Active Production

Eppendorf Centrifuge 5418 R

Eppendorf Centrifuge 5418 R — Centrifuges.

The Eppendorf Centrifuge 5418 R is a refrigerated benchtop microcentrifuge with a single fixed-angle rotor, reaching 14,000 rpm and 16,873 × g. It is the refrigerated member of the 5418 series, distinguished by active cooling for temperature-sensitive pelleting. It is used for routine 1.5/2.0 mL tube separations in molecular biology workflows.

Full specifications

Core Performance & Functional Specifications
Acceleration Time 1) 13 s
Deceleration Time 1) 13 s
Dimensions (w × D × H) 30 x 46 x 25 cm
Max. Rcf 16873 g
Max. Rcf With Fixed-angle Rotor 16873 g
Rotational speed 100...14000 rpm
Rotors available mfr 1
Dimensions, Weight & Mechanical Design
Height (with Open Lid) 52 cm
Product Weight 22 kg
Electrical, Power & Drive Specifications
Max. Power Consumption 320 W

Description

Construction and positioning

Drive and performance envelope

Installation and operation

Integration & Operating Notes

Cooling & Media
Refrigerant circuit uses R134a; observe local handling rules

The attached safety data sheet identifies the refrigerant as R134a (1,1,1,2-tetrafluoroethane, CAS 811-97-2, EC 212-377-0). Service or disposal of the cooling circuit must follow the regional requirements referenced in that sheet; no charge quantity or pressure is stated in the verified facts.

Safety Data Sheet R134a, version 4.0.0, 24.10.2022
Process Limits
Single fixed-angle rotor; no interchange specified

Verified data lists one rotor available and gives maximum RCF only for the fixed-angle rotor (16,873 × g). Do not assume compatibility with swing-out or other rotors from the wider Eppendorf range; confirm tube formats against the rotor actually fitted.

Factory Specification Sheet

Selection & Integration Q&A

When should I choose the 5418 R rather than the non-refrigerated 5418?

Choose the R when samples or downstream steps require temperature control during the run; the cooling circuit is the differentiator. For ambient-temperature pelleting where heat build-up is acceptable, the non-refrigerated sibling avoids the refrigerant circuit and its service obligations. Both share the 14,000 rpm / 16,873 × g envelope.

What bench services and clearances does the 5418 R need at the installation point?

Plan for the 30 × 46 cm footprint, 22 kg mass and 52 cm open-lid height. The verified facts give no voltage, current or plug type, so the electrical supply must be confirmed against the unit's nameplate before installation; no compressed air or water services are indicated.

What maintenance or consumables are outside the base delivery?

The verified documents contain no maintenance schedule, error-code list or accessory catalogue. The only attached document is the R134a safety data sheet, which addresses the refrigerant, not routine service. Rotor, adapters, tubes and any calibration or service parts must be specified separately; intervals are not stated in the supplied facts.

Can I rely on the 13 s acceleration/deceleration figures for method timing?

Treat them as nominal: the verified data does not state the rotor, load or speed at which 13 s applies, and no curve points are supplied. For reproducible protocols, time the actual run on the installed rotor rather than assuming 13 s across the 100–14,000 rpm range.

Dimensional Drawings & Technical Documentation

Technical documentation

PDF
General Certificate Material Safety Data Sheet MSDS Centrifuges Shaker
Datasheet ·242,7 КБ ·9 pp.
View PDF