Shimadzu Testing Machine FOR Rubber Vibration Isolators
Shimadzu ·Made in Japan · In Active Production

Shimadzu Testing Machine FOR Rubber Vibration Isolators

Shimadzu Testing Machine FOR Rubber Vibration Isolators — Testing machines.

The Shimadzu Testing Machine for Rubber Vibration Isolators is a dedicated electrodynamic test system with a 10 kN maximum test force and ±10 mm maximum displacement, purpose-built for characterizing rubber vibration isolators. Its 5–300 Hz cycle speed range and amplitude characteristics (e.g., ±2 mm at 50 Hz, ±0.18 mm at 300 Hz) define its operating envelope. It is used to determine dynamic stiffness and damping properties of elastomeric isolators under sinusoidal excitation.

Full specifications

Description

Integration & Operating Notes

Process Limits
Do not exceed amplitude–frequency envelope

Operating beyond the stated amplitude at a given frequency (e.g., >±2 mm at 50 Hz or >±0.18 mm at 300 Hz) may cause actuator over-travel, excessive force, or damage to the test machine and specimen. The envelope must be programmed into the test profile.

Factory Specification Sheet
Process Limits
Maximum test force of 10 kN must not be exceeded

The 10 kN force limit applies to both static and dynamic testing. Exceeding it, even momentarily during transients or resonance, can overload the force transducer and actuator, leading to invalid results or equipment damage.

Factory Specification Sheet
Mounting
Rigid, vibration-isolated foundation recommended

Although not specified in the supplied facts, dynamic testing machines typically require a massive, vibration-isolated foundation to prevent external vibrations from affecting measurements and to avoid transmitting reaction forces to the building. Verify site requirements with Shimadzu.

General engineering practice

Selection & Integration Q&A

When should I choose this machine over a general-purpose universal testing machine for rubber isolator testing?

Choose this dedicated machine when you need dynamic characterization (5–300 Hz) with controlled amplitude and up to 10 kN force. A universal tester lacks the high-frequency actuator and amplitude control required for isolator dynamic stiffness and damping measurements.

Dimensional Drawings & Technical Documentation

Technical documentation