No photo available yet
Nabertherm SAH 5600/..
Nabertherm SAH 5600/.. — Forced Convection Furnaces.
The SAH 5600/.. is a forced-convection pit-type furnace with a 5600 l chamber, designed for top-loading of heavy charges up to 5000 kg. Its 2700 × 3000 × 3900 mm outer envelope and 3-phase electrical connection define the installation footprint. It serves as a large-capacity batch furnace for uniform heat treatment of bulky loads.
Full specifications
| Chamber volume | 5600 l |
| Electrical connection | 3-phase |
| Heating mfr | 120 |
| Outer dimensions (W × D × H) mfr | 2700 × 3000 × 3900 mm |
| Max. charging weight mfr | 5000 |
Description
Construction and positioning
- Pit-type architecture: the chamber is accessed from above, allowing crane loading of charges up to 5000 kg.
- Chamber volume of 5600 l places this model at the large end of the SAH series; no sibling models are listed for direct comparison.
- Outer dimensions of 2700 × 3000 × 3900 mm (W × D × H) dictate the pit excavation and surrounding clearance.
- Heating is provided by a 120 (unit not specified in the source) system; electrical connection is 3-phase.
Behavior under load
- No digitized curve points or temperature-uniformity data are available for this model; performance must be confirmed against the factory specification sheet.
- The 5000 kg maximum charging weight is the governing load limit; exceeding it is not permitted.
- Forced convection is the series principle, but no airflow or heating-rate figures are provided in the verified facts.
Installation and control
- The controller documentation covers Nabertherm series 500 and the MyNabertherm app, including process data storage and AMS2750F instrumentation types; these are controller-platform facts, not model-specific settings.
- No model-specific installation, connection, or operating instructions are present in the attached document digests; refer to the furnace manual for pit preparation, lifting, and commissioning.
Integration & Operating Notes
The furnace outer envelope is 2700 × 3000 × 3900 mm; the pit and surrounding structure must be sized to this envelope with access for crane loading from above. Verify foundation load capacity against the furnace weight, which is not stated in the verified facts.
The maximum charging weight is 5000 kg. Loads, fixtures, and any basket or grid must be included in this figure; exceeding it risks damage to the hearth and charging equipment. Confirm the weight of the charge plus tooling before every loading cycle.
The furnace is connected to a 3-phase supply. The connected load, voltage, and current are not given in the verified facts; obtain the electrical data sheet from the factory before sizing cables, fuses, and the upstream disconnect.
The controller documentation covers Nabertherm series 500 controllers and the MyNabertherm app, including process data storage and AMS2750F instrumentation types. These are platform capabilities; the actual controller configuration for this furnace must be confirmed at order.
Selection & Integration Q&A
Choose this model when the charge requires a 5600 l chamber and weighs up to 5000 kg, loaded from above by crane. No sibling models are listed in the verified facts, so compare chamber volume and charging weight against other SAH sizes using the factory selection guide.
The furnace uses a 3-phase connection, but the verified facts do not state voltage, connected load, or current. Size cables, fuses, and the disconnect only after obtaining the electrical data sheet from the factory; do not assume a rating from the model code.
The verified facts list no maintenance schedule, spare parts, or included accessories. Controller options such as recorders and AMS2750F instrumentation are documented separately and should be specified at order; consult the furnace manual for service intervals.