No photo available yet
Eppendorf Bioprocess Autosampler
Eppendorf Bioprocess Autosampler — Bioreactors & fermenters.
The Eppendorf Bioprocess Autosampler is an automated sampling accessory for bioreactors and fermenters, available in single-head and dual-head configurations. It withdraws and delivers process samples without manual intervention, supporting hands-free monitoring of fermentation runs. The exact sample volume, cycle timing, and wetted-material specifications are not stated in the supplied verified facts.
Full specifications
Description
Construction and positioning
- The Bioprocess Autosampler is a sampling peripheral for bioreactor and fermenter systems, not a standalone vessel or analytical instrument.
- Two configurations are documented: a single-head variant and a dual-head variant. No sibling models within a wider series are listed, so positioning is limited to this head-count choice.
- No verified data is available on wetted materials, sterilization compatibility, sample volume, or line dimensions; these must be confirmed against the current Eppendorf specification before design freeze.
Behavior and process role
- The unit is intended to take samples from a running fermentation or cell-culture process without operator entry into the culture vessel, reducing contamination risk and manual handling.
- No digitized performance curves, flow rates, or cycle-time data were supplied, so no quantitative sampling behavior can be stated here.
- Because the brochure digest contains no actionable engineering facts, all process-facing claims should be treated as unverified until the full manual is obtained.
Installation and control
- The supplied document digest lists no sections, so mounting, connection, and control-interface details cannot be summarized from verified facts.
- Integration with the bioreactor control system, sample routing to an analyzer or fraction collector, and cleaning routines must be defined from the manufacturer's installation manual.
Integration & Operating Notes
No verified sample volume, cycle time, line length, or sterilization data were provided. Before specifying this unit, obtain the current Eppendorf datasheet and confirm that its sampling range and wetted materials match the vessel, the process temperature, and the downstream analyzer.
The document digest contains no interface section, so the available trigger signals, communication protocol, and handshake with the bioreactor control system are unknown. Confirm these before committing to an automated sampling schedule or integrating with a SCADA/DCS layer.
Selection & Integration Q&A
The verified facts list only that both single-head and dual-head variants exist. No throughput, timing, or sample-count data are supplied, so the choice cannot be made from these facts alone; request the Eppendorf configuration guide to compare sampling capacity and simultaneous sampling needs.
The supplied digest contains no interface or signal details. Confirm with Eppendorf the trigger/communication protocol, required handshake signals, and whether the unit operates standalone or under bioreactor controller command before designing the automation sequence.
No mounting, ambient-temperature, humidity, or IP-rating data are present in the verified facts. These must be obtained from the installation manual before siting the unit near the vessel, particularly in washdown or classified areas.
The supplied facts contain no maintenance schedule or accessory list. Request the recommended tubing/consumable replacement interval and confirm whether sample lines, fittings, and control cables are included or must be ordered separately.