Nabertherm DF 36/320/5/10 WK
Nabertherm ·Made in Germany · In Active Production

Nabertherm DF 36/320/5/10 WK

Nabertherm DF 36/320/5/10 WK — Furnaces Microelectronic Industry.

The DF 36/320/5/10 WK is a continuous belt furnace with a 360 mm belt width and 3200 mm heated length, divided into 7 heating zones and rated for a maximum temperature of 1050 °C. Its 47 kW installed heating power is distributed across the zone train to support a controlled burn-out and firing/sintering profile. It is intended for continuous thermal processing in microelectronic and related production lines.

Full specifications

Core Performance & Functional Specifications
Number of heating zones mfr 7
Heating power1 mfr 47
Dimensions, Weight & Mechanical Design
Belt width mfr 360
Heated length mfr 3200
Operating Conditions, Environment & Protection
Max temperature 1050 °C

Description

Construction and series positioning

Thermal behavior

Control and documentation

Integration & Operating Notes

Process Limits
Do not exceed 1050 °C at any point in the zone train

The only verified thermal limit is a maximum temperature of 1050 °C. Because the furnace has 7 heating zones, the setpoint of each zone and the resulting work temperature must be checked so that no zone or product excursion exceeds this ceiling; doing so risks damage to the furnace and invalid results.

Factory Specification Sheet
Electrical
47 kW heating power requires a dedicated supply design

The installed heating power is 47 kW, which is a substantial load for a production line. Electrical supply voltage, phase configuration and protection are not stated in the supplied facts, so the supply design must be confirmed against the actual nameplate and wiring diagram before installation.

Factory Specification Sheet
Maintenance
Belt and zone maintenance schedule is not documented here

No maintenance intervals, belt replacement guidance or error-code procedures for this model are included in the supplied documents. A maintenance plan for the belt drive and the 7 heating zones must be obtained from the model-specific instruction manual before commissioning.

Factory Specification Sheet

Selection & Integration Q&A

When should I choose the DF 36/320/5/10 WK rather than another variant of the series?

Choose it when the process needs a 360 mm belt and a 3200 mm heated length at up to 1050 °C with 7-zone profiling. No sibling models are defined in the supplied facts, so alternatives cannot be compared on belt width, length or zone count here.

What must be confirmed for the electrical supply and controller before connecting this furnace?

The 47 kW heating power load must be matched to the site supply, but voltage and phase are not stated in the supplied facts. The controller is likewise not fixed: the series 500/MyNabertherm digest describes options, not the fitted package, so both must be confirmed on the nameplate and order documents.

What mounting and duty-cycle limits apply to this continuous furnace?

The supplied documents give no installation clearances, floor loading or duty-cycle data for this model. The only verified limit is the 1050 °C maximum temperature; all mounting and cycling requirements must come from the model-specific manual.

What maintenance and accessories are needed beyond the base furnace?

No maintenance intervals, spare belts, thermocouples or recorder accessories are listed in the supplied facts. The controller digest mentions recorder and instrumentation options but does not tie them to this model, so consumables and service parts must be specified separately.

Dimensional Drawings & Technical Documentation

Technical documentation

PDF
Prozesssteuerung englisch
Brochure ·2,8 МБ ·20 pp.
View PDF
PDF
Fiber optics glass english 0
Brochure ·10,3 МБ ·97 pp.
View PDF
PDF
Foundry english
Brochure ·4,2 МБ ·52 pp.
View PDF
PDF
Dental english
Brochure ·13,1 МБ ·72 pp.
View PDF