Nabertherm NT 200 DB..
Nabertherm NT 200 DB.. — Furnace Solutions 1400 Degc.
The NT 200 DB.. is a 140-litre chamber furnace with a 1280 °C maximum working temperature and 3-phase electrical connection, built for single-zone heating control at 15 kW. Its 400 × 530 × 720 mm chamber and 500 kg mass place it as a mid-size batch unit for heat-treatment tasks below 1300 °C.
Full specifications
| Chamber volume | 140 l |
| Electrical connection | 3-phase |
| Heating power for single-zone heating control mfr | 15 |
| Inner dimensions (W × D × H) mfr | 400 × 530 × 720 mm |
| Outer dimensions (W × D × H) mfr | 850 × 1350 × 2220 mm |
| Weight | 500 kg |
| Max temperature | 1280 °C |
Description
Construction and series position
- Chamber volume 140 l; inner dimensions 400 × 530 × 720 mm (W × D × H); outer dimensions 850 × 1350 × 2220 mm (W × D × H).
- Single-zone heating control with 15 kW heating power; 3-phase supply.
- Maximum temperature 1280 °C, below the 1400 °C ceiling of the category path, so this model is the lower-temperature member of the 1400 °C furnace family.
- Unit weight 500 kg; floor or frame mounting must be planned for this mass.
Thermal behaviour
- No digitized curve points were supplied, so heat-up and uniformity behaviour cannot be quantified here. The 1280 °C limit is the governing process ceiling; operation above it is outside the model's rating.
- Single-zone control means one controlled temperature zone over the full 140 l chamber; no multi-zone profile data is available.
Control and documentation
- The attached controller digest covers the Nabertherm 500-series controllers and MyNabertherm app, including process-data storage and AMS2750F instrumentation types, but it prints no furnace model sizes or ordering codes; controller fit must be confirmed against the actual order.
- Other attached digests (fiber-optics glass, foundry, dental) describe different product lines and contain no NT 200 DB.. facts.
Integration & Operating Notes
The furnace is a 3-phase load with 15 kW of single-zone heating power. The site supply, protective device and cable cross-section must be selected for that connected load; no single-phase operation is described for this model.
The maximum working temperature is 1280 °C. Process setpoints, over-temperature protection settings and any connected controller limits must be set below this value; the 1400 °C figure in the category path is the family ceiling, not this model's rating.
The controller documentation covers the 500-series controllers, MyNabertherm app, process-data storage and AMS2750F instrumentation types, but does not tie any of them to this furnace code. Confirm which controller, recorder and instrumentation type are included before specifying data-logging or qualification requirements.
Selection & Integration Q&A
Pick it when the process stays at or below 1280 °C and a 140 l chamber of 400 × 530 × 720 mm suits the batch. If the work requires temperatures up to 1400 °C, this model's 1280 °C limit rules it out and a higher-rated family member is needed.
The furnace is a 3-phase load with 15 kW single-zone heating power. The feed, protective device and cable must be sized for that connected load; no single-phase variant is described, so the installation must provide a 3-phase supply at the furnace location.
The controller digest describes 500-series controllers, MyNabertherm app, process-data storage and AMS2750F instrumentation types but prints no furnace model codes, so the included controller and recorder scope must be confirmed at order; do not assume data logging is in the base delivery.