No photo available yet
Nabertherm NW 660/H
Nabertherm NW 660/H — Chamber kilns.
The NW 660/H is a five-side-heated chamber kiln with a 660 l chamber (600 × 1100 × 1000 mm) rated to 1340 °C and 52 kW on a 3-phase supply. It is a large-volume model in Nabertherm's drawer/shuttle kiln series, intended for batch heat treatment where uniform heating from all five sides is required.
Full specifications
| Chamber volume | 660 l |
| Electrical connection | 3-phase |
| Nominal power | 52 kW |
| Inner dimensions (W × D × H) mfr | 600 × 1100 × 1000 mm |
| Outer dimensions (W × D × H) mfr | 1070 × 1750 × 1830 mm |
| Weight | 1310 kg |
| Max temperature | 1340 °C |
Description
Construction and positioning
- Chamber kiln with 660 l working volume, inner dimensions 600 × 1100 × 1000 mm (W × D × H); outer dimensions 1070 × 1750 × 1830 mm, weight 1310 kg.
- Heated from five sides, per the series designation; maximum working temperature 1340 °C.
- Electrical: 3-phase connection, 52 kW nominal power. No voltage or current value is stated in the verified facts, so none is given here.
- No sibling models are listed in the verified data, so positioning within the series is limited to the series-level statement (drawer and shuttle kilns up to 1340 °C, five-side heating).
Behavior under load
- No digitized curve points were supplied, so heating/cooling rates and uniformity data cannot be stated. The only thermal limits available are the 1340 °C maximum and the 660 l chamber volume.
Control and operation
- The attached controller document covers Nabertherm controller series 500 and the MyNabertherm app, including process-data storage and AMS2750F instrumentation types, but it prints no furnace-specific settings for the NW 660/H. Controller configuration must therefore be confirmed against the furnace order documentation, not inferred from this card.
- The remaining attached digests (fiber-optics glass, foundry, dental) cover other product lines and contain no actionable facts for this model.
Integration & Operating Notes
The verified facts state only '3-phase' and 52 kW. No voltage or full-load current is printed, so the site supply, cable cross-section and protective device cannot be sized from this card; obtain the connection data from the model-specific nameplate or wiring diagram before installation.
The 1340 °C figure is the maximum working temperature of this model. Exceeding it risks damage to the five-side heating elements and chamber lining; process setpoints must be interlocked or limited below this value in the controller.
The controller digest describes series 500 functions, process-data storage and AMS2750F instrumentation types but gives no NW 660/H-specific parameters. Confirm the ordered controller variant and any recorder option against the order confirmation rather than assuming a default configuration.
Selection & Integration Q&A
Choose it when the batch needs a 660 l chamber (600 × 1100 × 1000 mm) at up to 1340 °C with five-side heating. No sibling models are listed in the verified data, so compare other sizes against this chamber volume and the 52 kW / 3-phase supply requirement.
The verified facts give only '3-phase' and 52 kW; no voltage or current is stated. Size cables and protective devices from the model-specific nameplate or wiring diagram supplied with the unit, not from this card.
The verified facts list no maintenance intervals, consumables or included accessories, and the attached documents contain no NW 660/H-specific service data. Obtain the maintenance schedule and accessory list from the furnace documentation supplied with the unit.