Nabertherm RS 50/250/13
Nabertherm RS 50/250/13 — Tube furnaces.
The RS 50/250/13 is a split-type tube furnace rated to 1300 °C, accepting tubes up to 50 mm outer diameter over a 250 mm heated length with an 80 mm constant-temperature zone. Its 2 kW single-phase element set and 37 kg frame suit horizontal or vertical laboratory duty where the split housing allows rapid tube exchange.
Full specifications
| Electrical connection | 1-phase |
| Nominal power | 2 kW |
| Max. outer tube Ø mfr | 50 |
| Weight | 37 kg |
| Heated length mfr | 250 |
| Max temperature | 1300 °C |
Description
Construction and series positioning
- Split-type tube furnace architecture: the housing opens to accept a 50 mm outer-diameter process tube; the 250 mm heated length and 80 mm constant-temperature zone define the usable hot region.
- Rated to 1300 °C with a 2 kW single-phase element set; the 37 kg frame is intended for bench or stand mounting in either horizontal or vertical orientation.
- No sibling models are listed for this series, so the RS 50/250/13 is the sole documented configuration; tube diameter and heated length are the fixed envelope.
Thermal behavior
- No digitized curve points are supplied; the only thermal facts are the 1300 °C maximum and the 80 mm constant-temperature length, which bounds the sample zone that can be held uniform.
- The 2 kW rating is the total connected load for the single-phase supply; no separate zone power split is documented.
Control and operation
- The attached controller digest covers the Nabertherm 500 series and MyNabertherm app, including process-data storage and AMS2750F instrumentation types, but prints no furnace-specific wiring or setpoint tables for this model.
- No installation, connection or operating procedure specific to the RS 50/250/13 appears in the supplied document digests; the remaining digests cover unrelated product lines (heating cabinets, foundry furnaces, dental furnaces) and are not applicable.
Integration & Operating Notes
The furnace is specified as a 1-phase, 2 kW unit; the actual voltage and current are not printed in the verified facts, so the supply must be confirmed against the nameplate before connection rather than assumed from the model code.
The 50 mm figure is the maximum outer tube diameter the split housing accepts; a larger tube will not seat in the furnace, and the 250 mm heated length plus 80 mm constant-temperature zone define where the workload can be placed.
The controller digest describes the 500 series and MyNabertherm app, including process-data storage and AMS2750F instrumentation types, but gives no model-specific wiring, sensor type or setpoint program for the RS 50/250/13; these must be taken from the furnace's own wiring diagram.
Selection & Integration Q&A
Pick it when the process needs a split housing for frequent tube exchange, a tube up to 50 mm OD, a 250 mm heated length with an 80 mm uniform zone, and 1300 °C from a 2 kW single-phase supply. Larger tubes or longer uniform zones require a different model; no siblings are documented for this series.
The verified facts give only 1-phase and 2 kW; the nameplate voltage and current must be read before wiring. The controller digest covers the 500 series and MyNabertherm app at series level only, so sensor type and wiring must come from the furnace's own diagram.
The supplied digests contain no maintenance schedule, service intervals, error codes or accessory list for the RS 50/250/13; the controller document covers only series-level functions. Tube, stand, controller cabling and consumables should therefore be confirmed with the factory rather than assumed included.