No photo available yet
Shimadzu Static Jack System
Shimadzu Static Jack System — Testing machines.
The Shimadzu Static Jack System is a hydraulic loading unit with a 1000 kN test force capacity and ±200 mm piston stroke, driven by a 40 L/min hydraulic power supply. It serves as the loading actuator in static testing machines, applying controlled force and displacement to specimens in compression or tension setups.
Full specifications
Description
Construction and positioning
- The Static Jack System is a hydraulic actuator module rated for 1000 kN test force and ±200 mm piston stroke. - It requires an external hydraulic power supply delivering 40 L/min; the jack itself does not include a pump or control electronics. ### Behavior under load
- The 1000 kN capacity defines the maximum static force the jack can apply; continuous operation near this limit depends on the duty cycle of the hydraulic supply. - The ±200 mm stroke allows bidirectional displacement, suitable for both compression and tension test setups within that range. - No digitized curve points or mode-specific performance data are available; behavior under load must be characterized through system-level testing. ### Installation and operation
- The jack must be integrated with a hydraulic power unit capable of 40 L/min flow at the required working pressure.
Integration & Operating Notes
The jack is rated for a maximum test force of 1000 kN. Exceeding this limit risks permanent deformation or failure of the piston and seals, and invalidates test results. Force monitoring and overload protection should be implemented in the control system.
The jack requires a hydraulic power supply with a capacity of 40 L/min. Insufficient flow will limit actuation speed and may cause cavitation or erratic motion. The supply must also maintain the pressure required to reach 1000 kN, which depends on the effective piston area.
Selection & Integration Q&A
The jack needs a hydraulic power unit capable of 40 L/min at the pressure required for 1000 kN. It does not include a pump, valves, or controller; these must be specified separately. Ensure the supply's pressure rating matches the jack's maximum working pressure, which is not stated in the provided data.
The base delivery includes only the jack; hydraulic hoses, fittings, power supply, control cables, and mounting hardware are not included. Maintenance intervals for seals and hydraulic fluid are not specified in the provided data; refer to the manual for service schedules.