Elmo Rietschle IDS
Elmo Rietschle IDS — Screw Vacuum Pumps.
The Elmo Rietschle IDS is a dry screw vacuum pump with a contact-free, oil-free pumping chamber. The IDS 850 and IDS 1100 variants are water-cooled as standard, with air cooling available on request; the IDS 850 is fixed-speed and the IDS 1100 is variable-speed. It is used where oil-free vacuum is required and condensable or particle-laden gases must be handled without lubricant contamination.
Full specifications
| Lubrication type | dry |
| Operating principle | dry screw |
Description
Construction and series positioning
- Dry screw operating principle: two intermeshing rotors rotate without contact, so no sealing oil enters the pumping chamber.
- The IDS series comprises the IDS 850 (fixed-speed) and IDS 1100 (variable-speed); both are water-cooled as standard, with air cooling available on request.
- This model is the dry screw vacuum pump itself; no additional series siblings are listed in the verified data.
Behavior under load and media
- Because the screws do not touch, the pump is suited to media that would degrade oil-lubricated pumps, but no specific gas compatibility, particle tolerance, or condensate limits are stated in the verified facts.
- No performance curves or pressure ranges are available for this model; capacity and ultimate pressure must be confirmed against the order-specific data sheet.
Installation, connection, and operation
- The verified document digest contains no installation, connection, control, or operation details; the following notes are therefore limited to general dry screw pump practice and must be verified against the full instruction manual before commissioning.
Integration & Operating Notes
The verified facts do not state allowable inlet gas temperature, particle loading, condensate tolerance, or solvent compatibility. These must be obtained from the full manual or factory before applying the pump to a process stream, because exceeding unstated limits can damage the screw set or seals.
Selection & Integration Q&A
Choose the IDS 850 when the process runs at a fixed operating point and does not need speed turndown. Choose the IDS 1100 when variable speed is required for process control or energy saving; it is the variable-speed variant of the same dry screw series.
The verified facts do not state ambient temperature, altitude, or mounting orientation limits. These must be confirmed from the full instruction manual before installation; do not assume indoor/outdoor or high-altitude suitability without factory confirmation.
No maintenance schedule, spare parts list, or accessory scope is given in the verified facts. Cooling water connections, inlet filtration, and control hardware for the IDS 1100 must be confirmed against the order-specific documentation; they are not described as part of the base pump delivery.