BINDER KBF 470
BINDER KBF 470 — Climate chambers with Temperature 0…70 °C.
The BINDER KBF 470 is a 472 L constant climate chamber with a 0...70 °C temperature range and 10...80 % RH humidity control, housed in a 930 mm wide cabinet. It is the mid-size standard model in the KBF series, distinguished from smaller 130/260 and larger 1060/1600 siblings by its 40 kg per-rack load capacity and 530 W max heat compensation. It serves as a programmable test station for reproducible temperature and humidity conditioning of samples in laboratory and industrial qualification workflows.
BINDER KBF Series — Model Comparison & Selection
Full specifications
| Temperature | 0...70 °C |
| Interior volume | 472 L (KBF470-230V / KBF470UL-120V) |
| Load per rack | 40 kg (KBF470-230V / KBF470UL-120V) |
| Maximum heat compensation | 530 W |
| Nominal power | 1.4 kW (KBF470-230V / KBF470UL-120V) |
| Temperature fluctuation | 0.1 K |
| Temperature uniformity | 0.2 K |
| Article Number mfr | 9020 |
| Recovery time after door was opened for 30 s at 25°C and 60% RH mfr | 2 min |
| Recovery time after door was opened for 30 s at 40°C and 75% RH mfr | 4 min |
| Height | 1951 mm (KBF470-230V / KBF470UL-120V) |
| Width | 930 mm (KBF470-230V / KBF470UL-120V) |
| Power frequency | 50/60 Hz (KBF470-230V / KBF470UL-120V) |
| Rated voltage | 220...240 V |
| Unit fuse | 16.0 A (KBF470-230V / KBF470UL-120V) |
| Humidity fluctuation | 1.5 % RH |
| Humidity range | 10...80 % RH |
Description
Construction and series positioning
- The KBF 470 (article 9020-0480, designation 470-230) is a floor-standing constant climate chamber with 472 L interior volume, 930 mm net width and 1,951 mm net height. It uses a single-phase 220...240 V, 50/60 Hz supply at 1.4 kW nominal power and a 16.0 A unit fuse.
- Within the KBF series it sits between the 260 and 1060 models; all siblings share the 0...70 °C base range, but the 470 is the size that combines a 40 kg per-rack load with 530 W maximum heat compensation, making it suitable for racks carrying moderately dense sample loads.
- Unlike the KBF PRO variants, which extend the temperature and humidity range, this standard KBF 470 is limited to 10...70 °C when humidity control is active; the full 0...70 °C range applies only in dry operation.
Behavior under load and in humidity mode
- Temperature fluctuation is 0.1 K and temperature uniformity 0.2 K, so the chamber holds a tightly defined working volume around the setpoint. Humidity fluctuation is 1.5 % RH across the 10...80 % RH control band.
- Recovery after a 30 s door opening is 2 min at 25 °C / 60 % RH and 4 min at 40 °C / 75 % RH, which sets the practical interval for sample loading and handling without losing the conditioning envelope.
- The 530 W maximum heat compensation defines the permissible heat load from samples or equipment inside the chamber; exceeding it will disturb the temperature/humidity balance.
Installation, control and operation
- The chamber is controlled by the MB2 controller with fixed-value, time-program and week-program modes, a chart-recorder display, alarm and notification functions, and user management with password-protected authorization levels.
- Temperature safety is provided by an over-temperature protective device class 1 plus an overtemperature safety controller class 2/3.3 (selectable as temperature limiter or temperature protection) and undertemperature protection class 3.2, per DIN 12880:2007.
- From size 260 upward a wall spacer is required; the 470 additionally uses the flexible tilt protection kit. Water connections for humidification are on the rear panel, and the humidifying/wastewater design depends on the serial number break at 20250000010225/20250000010226.
Integration & Operating Notes
With humidity active the working range narrows to 10...70 °C; the full 0...70 °C range is available only in dry operation. Humidity is controlled between 10 and 80 % RH with 1.5 % RH fluctuation. Programming a humidified setpoint below 10 °C or outside the RH band will not be reached and may trigger humidity-system alarms.
The 530 W maximum heat compensation is the total heat that samples or powered equipment inside the chamber may introduce without disturbing temperature and humidity control. Each rack is rated for 40 kg. Exceeding either limit invalidates the specified 0.1 K fluctuation and 0.2 K uniformity and can drive the chamber into alarm.
Regular maintenance must be performed at least once a year, including the steam humidifier, and the condensers should be cleaned at least twice a year by a qualified technician (more often in dusty ambient air). After 8760 operating hours or two years the controller shows a maintenance message that recurs every two weeks until reset by BINDER Service. Refrigeration work requires personnel trained per EN 13313:2010.
The door gasket must be replaced with the chamber at ambient/cold condition; replacing it while warm can damage the gasket and compromise the seal, which in turn affects recovery time and humidity stability. Schedule gasket replacement during planned downtime before a conditioning run.
Selection & Integration Q&A
Pick the 470 when 472 L interior volume and 40 kg per-rack load with 530 W heat compensation fit the sample batch; the 260 is smaller, while the 1060 and 1600 add capacity but not a wider standard temperature range (all 0...70 °C).
The 230 V model needs 220...240 V, 1~, 50/60 Hz, 1.4 kW, protected at 16.0 A. The UL variant (9020-0496) is a separate 120 V unit with NEMA 5-20 plug; choose it only where 120 V is the site supply, as the two are not interchangeable.
As a size 260-and-larger chamber it requires the wall spacer to maintain the specified wall distance, and the 470 specifically uses the flexible tilt protection kit. Both are needed for correct airflow and safe loading.
Annual maintenance (including steam humidifier) and twice-yearly condenser cleaning are user responsibilities; the maintenance reminder appears at 8760 h or two years. Options such as APT-COM 4, analog outputs, zero-voltage alarm contacts, internal LED light, door lock, Pt 100 object sensor and external water cans are ordered separately.